Is it possiblre to log parameters from Megashift:
gear, trans temperature, lever position... on the SD from MS3? I quickly looked for that last Saturday but I did not find it.
Guillaume
Logging transmission parameter with MS3 SDcard
-
Bernard Fife
- Posts: 1696
- Joined: Fri Apr 04, 2008 1:28 pm
Re: Logging transmission parameter with MS3 SDcard
Guillaume,
It's certainly possible, since the CAN infrastructure allows this. The MShift implementation of the CAN protocol is exactly the same as the 2.905 (and higher) MS-II code from B&G. However, I have no idea about whether ms3 supports this without changes, or whether code changes to ms3 are required. You would have to ask the developers of ms3 about this (on msextra.com).
Lance.
It's certainly possible, since the CAN infrastructure allows this. The MShift implementation of the CAN protocol is exactly the same as the 2.905 (and higher) MS-II code from B&G. However, I have no idea about whether ms3 supports this without changes, or whether code changes to ms3 are required. You would have to ask the developers of ms3 about this (on msextra.com).
Lance.
"Never wrestle with pigs. You both get dirty and the pig likes it." - George Bernard Shaw