help with dsg setup

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
Post Reply
Posts: 1
Joined: Mon Jan 02, 2017 3:06 am

help with dsg setup

Post by Moon_walk »

Hi there

i'm looking into having megashift controlling a 7speed dsg transmission

and was wondering if you guys could give me a hand ?

what i do have is 8 solenoids controlling shift forks and 2 clutch solenoids

4 magnetic shift sensors and speed sensors

what i need is to make it shift and listen to shift sensors when to use shift valves . .this can of course be adressed using the hall sensors to contol valves

but how do i cusomize it to use the clutches ? it's one for even gears and one for odd gears

best regards
Post Reply