zf 5hp30

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
Forum rules
Post Reply
minimiglia0
Posts: 1
Joined: Thu Aug 04, 2011 5:23 am

zf 5hp30

Post by minimiglia0 »

hi there i am currently building a 1938 morris ten hot rod which i am fitting a bmw 4.0 litre v8 with zf 5hp30 gearbox from a 1993 bmw 540.
just wondering if this controller will go any where near controlling this box

many thanks mike
Top
Bernard Fife
Posts: 1696
Joined: Fri Apr 04, 2008 1:28 pm

Re: zf 5hp30

Post by Bernard Fife »

Mike,

Read this: http://www.msgpio.com/manuals/mshift/newtrans.html You need to answer those questions (as a minimum to using MShift code on a GPIO controller for your trans). If you have questions about the questions, ask them here.

Lance.
"Never wrestle with pigs. You both get dirty and the pig likes it." - George Bernard Shaw
Top
Bemyy
Posts: 1
Joined: Mon May 27, 2013 11:16 am

Re: zf 5hp30

Post by Bemyy »

Hi,

I got same kind project BMW 540 V8 M60b40 motor with megasquirt3 and trnasmission ZF5HP30 with Mshift. Are you got transmission wortk it with MShift?
I'd like to hear what is going on. Maybe you can help me with this MShift problem.
Top
Post Reply

Return to “MegaShift Transmission Application”