minimum pressure of 40%

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
mill3833
Posts: 72
Joined: Mon Jan 27, 2014 3:33 pm

Re: minimum pressure of 40%

Post by mill3833 »

Lance,

4.138 did the trick. I can now command 0% PC in Park if I want.
Thanks again for excellent support.

Dave
Bernard Fife
Posts: 1696
Joined: Fri Apr 04, 2008 1:28 pm

Re: minimum pressure of 40%

Post by Bernard Fife »

Dave,

I'm glad that worked. The code has become quite complex, so finding these things often takes a little longer than I like. I will update the 5.xxx code with the same fix shortly <edit>it turns out that section of the 5.xxx code had already been re-written (for use as spare port 3) so it ought to be okay 'as is'.</edit>. Both will be released in the code updates thread.

Lance.
"Never wrestle with pigs. You both get dirty and the pig likes it." - George Bernard Shaw
Post Reply