Flashing Megashift Firmware

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
Forum rules
Post Reply
shaodome
Posts: 58
Joined: Thu Aug 22, 2013 6:28 am

Flashing Megashift Firmware

Post by shaodome »

Is there a way to do this over CAN or do I need to wire up a little serial connection to the GPIO board per the build manual to do this initially?
Top
Bernard Fife
Posts: 1696
Joined: Fri Apr 04, 2008 1:28 pm

Re: Flashing Megashift Firmware

Post by Bernard Fife »

shaodome,

You need a serial connection to flash the code.

Lance.
"Never wrestle with pigs. You both get dirty and the pig likes it." - George Bernard Shaw
Top
Post Reply

Return to “MegaShift Transmission Application”