MSgpio.com read only forums (Jan.15,2018)

Just got done building and installing the MegaShift and can not get the code to load. Using the downloader program, error comes back as timed out. Where do I begin to troubleshoot this? I have brought the serial connections out through the Amp connector as per the build guide. Port checker program returns "s" on port that I am using.

Silverado,

Use the MS-II connection troubleshooting guide here: http://www.megamanual.com/connect.htm#ms2 The GPIO serial connection and software is the same as MS-II.

The bootloader header on the GPIO (that you must short to get into bootloader mode, usually by placing a jumper across it then powering up) is located right beside the serial jack at the edge of the board.

Lance.

i originally had the same problem and found I had the Tx and Rx wires REVERSED...after i checked them 3 times :O
This is probably not the case for you, but worth double checking
Rob

I had the same problem with forgetting about the T-R serial crossover, but correcting that I have both serial and CAN connections. I would like to test further before buying a transmission. Where can I buy a transmission stim board? The last post about the stim I could find was two years ago.

Best regards, John

John,

I have made and distributed updated trans stim boards over the last several months, but I am out of them at the moment.

If enough people (say 8 or 10) express an interest in these, I will have another run made. People can either post here, or PM me.

Lance.

Thanks for all of the responses. I had originaly thought that the Tx and Rx might be reversed - tried that and just got an error, unkown exception error I think. I built this for the 4L80E as per the build instructions. In the instructions to bring the serial out through the Amp plug it said to use one of the 17 - 20 pins for the ground, I used 19. I found that there was zero resistance from the gound pin of the voltage regulator on both 18 and 20 - I had both grounded to the trans case. On pin 19 that I used, I found about 4K ohm to the ground pin of the regulator. I switched 19 and 20, has zero resistance and it worked when I attempted to load the s19. Now on to see if this talks to my MSII.

Silverado

Silverado,

Sounds like you are making progress. If you can load code, then the serial comms are working. The tuning software should work too, with the right INI in place.

There is a video on the site for setting up the CAN comms to MS-II in TunerStudio. It is linked off of this page: http://www.msgpio.com/manuals/mshift/cpt.html (among other places)

Lance.

Lance,

The CAN comm appears to be working fine as well. I am looking forward testing and driving.

Silverado

Silverado,

That's great! The CAN comms are very reliable, in my experience (even more than the serial comms). Have fun with the install and testing, and be sure to let us know how it goes (and if there is anything that doesn't work or you don't understand, of course).

Lance.