GPIO vs Microsquirt TCU

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
Forum rules
Post Reply
sam3481
Posts: 3
Joined: Sun Sep 25, 2016 7:48 pm

GPIO vs Microsquirt TCU

Post by sam3481 » Thu Nov 03, 2016 7:46 am

Whats better?
I understand the microsquirt can tcu has a nice plug and play harness now but for a custom application this would not be helpful so what are the advantages or disadvantages for each.

Its been my personal experience that the GPIO is a bit fickle with the firmware getting corrupted but maybe its just me.

I would like to hear some suggestions.


-Sam
Top
Post Reply

Return to “MegaShift Transmission Application”