Re: non-CANbus will not come out of bottom of shift table
Posted: Tue Apr 29, 2014 6:10 pm
Well I built the NCV1124 circuit as per ashford's diagram and can't seem to get it to trigger at all, so I spent some time adding a capacitor to the input signal without the chip to try and dampen the low frequency. It seemed to work for now after a short drive, no more spikes to 100 right after moving. It will pop up to 8 mph but will settle immediately. I will try the LM2907 later when I have some time. I don't have a oscilloscope so it is hard to diagnose these problems.