I am having trouble with the pressure controls calculation and it accuracy off of the table. No matter what I do, the calculation is coming up a bit low based on what it should from the table.
Here is a good example of the problem. Pressure control (100-PWM) should be 90 and it being calculated at 77. This is on a bench set up for a 47RE which I am trying to mimic a Governor control I have gone trough the all the fields and zeroed out any that could effect this. One week later I have not figured it out yet. using 5.201
- tune with step on PC Feb 19.msq
- (62.24 KiB) Downloaded 1069 times