ZF 5HP24

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
Post Reply
Posts: 1
Joined: Thu Dec 08, 2016 1:04 pm

ZF 5HP24

Post by Shabs »


Has anyone had Megashift running a ZF 5HP24?

I've got a project im doing where i want to run a BMW 4.4 engine on standard ecu and with the standard auto box all in a different car. I dont want to run the standard gearbox ECU.

In an ideal world im looking for a plug and play solution...

Has anyone done it, can it be done and if so who has the facility/capability?

Thanks in advance!
Post Reply