TS going off-line, Fried GPI5?

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
Forum rules
Post Reply
Bernard Fife
Posts: 1696
Joined: Fri Apr 04, 2008 1:28 pm

Re: TS going off-line, Fried GPI5?

Post by Bernard Fife »

Tobmag,

There is no alternative input for this function. If this was mine, I would certainly try re-loading the code first on the chance it has been corrupted in some way.

Lance.
"Never wrestle with pigs. You both get dirty and the pig likes it." - George Bernard Shaw
Top
tobmag
Posts: 206
Joined: Mon Jan 02, 2012 4:22 am

Re: TS going off-line, Fried GPI5?

Post by tobmag »

Ok Ill try that tonight but if this is not solwing the issue is there some easy fix just to disable the function or its not needed?
Everything seems to work even though it says that the button is pressed.

BR//Tobmag
Top
tobmag
Posts: 206
Joined: Mon Jan 02, 2012 4:22 am

Re: TS going off-line, Fried GPI5?

Post by tobmag »

So ....

Reloaded the code but no luck, down button is still activated according to TS.
It also says Im in manual mode so I guess the unit will work though I will not be able to use the shift buttons?
Read somehwere that the code will disregard the command of up/down shift if the button is continuosly pressed?

BR//Tobmag
Top
Post Reply

Return to “MegaShift Transmission Application”