Transtim complete, I think

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
Forum rules
Post Reply
tmoble
Posts: 55
Joined: Fri Nov 25, 2011 1:01 pm
Location: Glendale, Az

Transtim complete, I think

Post by tmoble »

This is my first PCB based project, I've done some tube stereo amp stuff that was hardwired but no experience with this. Wasn't too bad after I got Digikey to send the right stuff. Anybody who knows bout this stuff, please look over my build, see if you see anything goofy.

Anyway, a few pics:
Attachments
DSCF6852.JPG
DSCF6852.JPG (480.13 KiB) Viewed 194002 times
DSCF6850.JPG
DSCF6850.JPG (478.52 KiB) Viewed 194002 times
DSCF6848.JPG
DSCF6848.JPG (484.49 KiB) Viewed 194002 times
Top
tmoble
Posts: 55
Joined: Fri Nov 25, 2011 1:01 pm
Location: Glendale, Az

Re: Transtim complete, I think

Post by tmoble »

a couple more
Attachments
DSCF6861.JPG
DSCF6861.JPG (484.5 KiB) Viewed 194000 times
DSCF6857.JPG
DSCF6857.JPG (483.63 KiB) Viewed 194000 times
DSCF6854.JPG
DSCF6854.JPG (485.27 KiB) Viewed 194000 times
Top
tmoble
Posts: 55
Joined: Fri Nov 25, 2011 1:01 pm
Location: Glendale, Az

Re: Transtim complete, I think

Post by tmoble »

last
Attachments
DSCF6862.JPG
DSCF6862.JPG (463.97 KiB) Viewed 194000 times
Top
tmoble
Posts: 55
Joined: Fri Nov 25, 2011 1:01 pm
Location: Glendale, Az

Re: Transtim complete, I think

Post by tmoble »

hmpf, phpBB posts the pics in reverse order. I'd forgotten about that if I ever knew.
Top
Post Reply

Return to “MegaShift Transmission Application”