MS3 1.4.X CAN OFFSET on 4.146

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
Rukavina
Posts: 47
Joined: Fri Aug 15, 2014 7:58 pm

Re: MS3 1.4.X CAN OFFSET on 4.146

Post by Rukavina » Tue Jul 04, 2017 11:00 pm

Back in vegas 8-)
Not sure my tunes will help you being I am on ms2 and 4l80e but I will put them up tomorrow

Post Reply