Enable extra solenoids in TS?

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
Post Reply
Jim Blackwood
Posts: 222
Joined: Tue Dec 07, 2010 9:52 am

Enable extra solenoids in TS?

Post by Jim Blackwood » Wed Apr 12, 2017 9:06 am

In my shift outputs pattern dialog everything below output 3 is greyed out. The chart goes up to output 11 and I need some or all of those outputs. How do I enable them?

Jim

Matt Cramer
Posts: 55
Joined: Thu Apr 17, 2008 5:19 am

Re: Enable extra solenoids in TS?

Post by Matt Cramer » Fri May 12, 2017 6:41 am

Can you post the complete MSQ?

Post Reply