You're absolutely right. Works a charm now.
I had missed the general GPIO build part. Oops.
Search found 5 matches
- Fri May 25, 2012 7:30 am
- Forum: MegaShift Transmission Application
- Topic: Upshift pressed always on. 4L80E
- Replies: 5
- Views: 11779
- Fri May 11, 2012 7:34 am
- Forum: MegaShift Transmission Application
- Topic: Upshift pressed always on. 4L80E
- Replies: 5
- Views: 11779
Re: Upshift pressed always on. 4L80E
Lance,
I didn't populate VR2 as I don't use the up and downshift buttons (yet). Even if I pull the respective jumper, PT6 VR2 in this case, the situation stays the same. I've measured between PT6 and ground to check for a ground path and no, infinitive.
I didn't populate VR2 as I don't use the up and downshift buttons (yet). Even if I pull the respective jumper, PT6 VR2 in this case, the situation stays the same. I've measured between PT6 and ground to check for a ground path and no, infinitive.
- Fri May 11, 2012 4:06 am
- Forum: MegaShift Transmission Application
- Topic: Upshift pressed always on. 4L80E
- Replies: 5
- Views: 11779
Upshift pressed always on. 4L80E
Hi,
On my 4L80E the upshift pressed light is always on. Is this normal? It does say it is in auto mode as soon as the controller fires up and stays there.
I also cannot find any schematics on how this cirquit is supposed to work, nor does it mention anything in the build manual. Am I overlooking ...
On my 4L80E the upshift pressed light is always on. Is this normal? It does say it is in auto mode as soon as the controller fires up and stays there.
I also cannot find any schematics on how this cirquit is supposed to work, nor does it mention anything in the build manual. Am I overlooking ...
- Wed Apr 11, 2012 5:15 am
- Forum: MegaShift Transmission Application
- Topic: 4L80E PC always 100 percent
- Replies: 3
- Views: 8696
Re: 4L80E PC always 100 percent
Hi Lance,
Thanks for your reply. I hadn't thought of the RPM input issue yet. This could very well be it. The MS currently just suplies the load (MAP) and CAN communications. I had tried to hook up RPM's but didn't work and I figured that as long as there is an input speed sensor this would not be ...
Thanks for your reply. I hadn't thought of the RPM input issue yet. This could very well be it. The MS currently just suplies the load (MAP) and CAN communications. I had tried to hook up RPM's but didn't work and I figured that as long as there is an input speed sensor this would not be ...
- Wed Apr 11, 2012 1:10 am
- Forum: MegaShift Transmission Application
- Topic: 4L80E PC always 100 percent
- Replies: 3
- Views: 8696
4L80E PC always 100 percent
Hi,
I've built and installed MShift on a 4L80E and after a few hiccups everything's working. Using an MS-2 for now but will be switching to non-Can when everything's sorted out. Already using ISS as tach input. Just 2 issues that need sorting out:
1. VSS drops to zero every now and then, always at ...
I've built and installed MShift on a 4L80E and after a few hiccups everything's working. Using an MS-2 for now but will be switching to non-Can when everything's sorted out. Already using ISS as tach input. Just 2 issues that need sorting out:
1. VSS drops to zero every now and then, always at ...