Page 1 of 1
Stepper Idle Up / Advance not working
Posted: Sun Nov 02, 2014 5:12 am
by shaodome
So I'm on a recent 5.x code for Megashift and finally got around to hooking up the idle motor, which is driven off the stepper chip via an MSPro. I noticed despite all the criteria being met for the in "D" but stopped to idle up not working. It says that it is for MS2 in tuner studio, so I'm imagining things are in a different place for MS3. Have you looked at that lance?
Re: Stepper Idle Up / Advance not working
Posted: Sun Nov 02, 2014 5:59 am
by Bernard Fife
Shaodome,
I don't know if the extra code developers have implemented this. I have been told that they have put the adjustment parameters in place but haven't put the code in place to actually use the received adjustments. Apparently they may be working on it. So ask on the extra forums about it.
The relevant parameters and code mechanisms have been in B&G code for a long, long time; and the advance, etc. works fine with B&G code last time I looked.
Lance.