Back up light schematic

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
Post Reply
Addicted
Posts: 188
Joined: Mon Oct 14, 2013 7:14 am
Location: Winchester, England

Back up light schematic

Post by Addicted »

I want to build one of my VR circuits (only thing left free) to give me an output for my reversing lights. The 'input' will be a 5v digital signal from the Arduino Pro Mini that controls my alphanumeric gear indicator.

So basically I need to build a MS GPIO VR circuit to use a 5v digital input to control a 12v automotive relay.

Has anyonw done this?
Post Reply