Page 1 of 1
feature request for shift retard
Posted: Mon Oct 08, 2012 4:42 am
by ashford
can it be brought out to an external output? this would be nice for standalone use to hook it to a 2-step, or for use on the ms3 flatshift to cut injectors.
Re: feature request for shift retard
Posted: Wed Oct 10, 2012 2:06 pm
by Bernard Fife
ashford,
I am not sure what you are asking for. The shift retard is sent as a CAN message to MS2/3. How do you envisage an output configure the retard signal for a standalone application?
Lance.
Re: feature request for shift retard
Posted: Thu Oct 11, 2012 5:13 am
by Matt Cramer
I believe he's asking for the ability to trigger a relay control or on/off output when the shift retard is active.
Re: feature request for shift retard
Posted: Thu Oct 11, 2012 6:54 am
by Bernard Fife
Matt,
If that is the case, then the 'selective clutch' spare port outputs already do this. See:
http://www.msgpio.com/manuals/mshift/spareport.html
Lance.
Re: feature request for shift retard
Posted: Fri Oct 12, 2012 5:35 am
by ashford
my goal is to have a fuel cut during shifts at high loads, this will be on a turbo car and i think ignition retard won't be enough power reduction. this will also be useful on a standalone if the vehicle has a 2-step.
i looked through tuner studio and the way i understand it is turn on selective clutch turn on 1-2,2-3,3-4 and set pwm to 100%?