MSgpio.com read only forums (Jan.15,2018)

Hello all, I'm an MS newbie but an experienced mechanic. I am in the planning stages of an engine swap project using a HO 3.5l Chrysler V6 with the 42le transmission. I am looking at using MegaSquirt for the engine control and MegaShift for the trans. I found an older thread about the 41te trans, and it looks like electrically it's the same as the 42le so I am assuming the I can use the 41te setup.

Would that be a correct assumption?

I'm looking at the GPIO-K basic kit, but the only trans kit available is for the 4L60e and 4L80e. What would I need to purchase to make it work with the chyrsler trans?

Thanks

sj,

You might want to email DIYAutoTune and ask them directly: websales@diyautotune.com

Lance.