EGT over CAN
Posted: Tue Jun 19, 2012 2:17 am
Hi There. I am struggling to display egt on Tuner studio. I have been battling this for a while and need some help please.
I have built the EGT2 input on the GPIO board, and have 0-5V appearing on the AD4 input pin when the thermocouple is heated.
Tuner studio indicates can pass through is working - I can select the 'Clock-time' to be displayed from the 'Gauge Templates (GPIO)' menu - it counts up in seconds. egt2 just appears as a static number.
I am not sure if I have configured the OutputChannels in the ini's correctly. Code hints in Set Up OUTPC of main.c - template 1.000 says
"corresponding values should be in the MegaTune INI [OutputChannels] section."
does this mean the corresponding values should be in the MS.ini or the GPIO.ini. If they are supposed to be in the MS.ini - how do you correctly set the offset?
I'm more than a little confused here. Any help would be appreciated.
I have built the EGT2 input on the GPIO board, and have 0-5V appearing on the AD4 input pin when the thermocouple is heated.
Tuner studio indicates can pass through is working - I can select the 'Clock-time' to be displayed from the 'Gauge Templates (GPIO)' menu - it counts up in seconds. egt2 just appears as a static number.
I am not sure if I have configured the OutputChannels in the ini's correctly. Code hints in Set Up OUTPC of main.c - template 1.000 says
"corresponding values should be in the MegaTune INI [OutputChannels] section."
does this mean the corresponding values should be in the MS.ini or the GPIO.ini. If they are supposed to be in the MS.ini - how do you correctly set the offset?
I'm more than a little confused here. Any help would be appreciated.