shifter position switch required or not?
Posted: Sun Oct 02, 2016 1:02 am
I have a 4L60E out of a Impala police car. It apparently had the shift lever position sensor on the steering column since there was no room at all on the side of the trans for it. I thought I had to have it, so I bought a different shift shaft that stuck out of the case further and installed it. I rounded up the switch sensor gizmo that bolts to the side of the trans, installed it. It has two electrical connectors on it. Now, I'm looking through the wiring diagrams getting ready to install and wire this thing and I don't see anything about connections to it. This is in a 57 Chevy pickup with a TPI 355, so there's nothinh on the truck.
So, do I need wiring to this switch gizmo or not? If so, is there a wiring diagram that shows how to hook it up somewhere?
So, do I need wiring to this switch gizmo or not? If so, is there a wiring diagram that shows how to hook it up somewhere?