Page 4 of 4
Re: Shift to 5th from Park
Posted: Sat Apr 23, 2011 1:22 pm
by gurov
i'm gonna go test this out right now (4.004 and the 2.1 latest) as i have some time to kill.
Re: Shift to 5th from Park
Posted: Sun Apr 24, 2011 5:11 am
by gurov
2.106 works, 4.004 does not. same story with 4.004, i even tried to set it to 1 for shift_mode.
paddles also do not have any affect on the code when it's in "drive". they just stay all pressed, even when i go into the mode where paddles are all released.
would it matter if the paddles are always pressed to together on start, with the whole debounce thing, does it need an "off" state to start out with ?
drove 120-ish miles on 2.106, 3rd shift is still harsh and instant, manual shift modification works fine, using 1sec tapering TCC now for slightly smoother engagement.
Re: Shift to 5th from Park
Posted: Sun Apr 24, 2011 5:29 am
by Bernard Fife
MSQ and datalog?
Re: Shift to 5th from Park
Posted: Sun Apr 24, 2011 5:42 am
by Bernard Fife
gurov,
Okay, I am seeing the non-responsive shift buttons on my bench. I will work on this - it shouldn't be too hard to sort out.
Lance.
Re: Shift to 5th from Park
Posted: Sun Apr 24, 2011 11:31 am
by Bernard Fife
gurov,
I have isolated the problem, but not the solution just yet. I am checking several hypothesis. It may be a day or two before I have some code that works. I will post fixed code in the 'Latest Code Updates' thread when it is ready.
Lance.
Re: Shift to 5th from Park
Posted: Sun Apr 24, 2011 12:51 pm
by gurov
Lance wrote:gurov,
I have isolated the problem, but not the solution just yet. I am checking several hypothesis. It may be a day or two before I have some code that works. I will post fixed code in the 'Latest Code Updates' thread when it is ready.
Lance.
cool.
there's still the issue where after shifting into drive with 4.004, it won't shift out of it going into N R and P.
Re: Shift to 5th from Park
Posted: Sun Apr 24, 2011 12:54 pm
by gurov
Re: Shift to 5th from Park
Posted: Sun Apr 24, 2011 8:17 pm
by Bernard Fife
gurov,
I tried the 4.005 code (from the beta code page) with your MSQ (2011-04-24_15-49-08.msq) and it appeared to work as expected on my bench (though I couldn't duplicate all the gear lever positions easily). I will keep testing here, let me know if it still doesn't work for you.
Lance.