Re: ZF 4HP24 Support
Posted: Fri Jun 21, 2013 2:47 am
Hi,
Great news that you have a 4HP24 working. I'm about to start work on a 5HP24, and I'm hoping I can learn from your experience.
The EDS1 servo provides primary pressure regulation on the 5HP - have you worked out duty cycles to control this on the 4HP? Is there a pressure sensor to enable closed loop pressure control, or have you devised some open-loop control?
I'm also keen to engage TCC as much as possible, and use in fully manual mode.
Nick
Great news that you have a 4HP24 working. I'm about to start work on a 5HP24, and I'm hoping I can learn from your experience.
The EDS1 servo provides primary pressure regulation on the 5HP - have you worked out duty cycles to control this on the 4HP? Is there a pressure sensor to enable closed loop pressure control, or have you devised some open-loop control?
I'm also keen to engage TCC as much as possible, and use in fully manual mode.
Nick