Input not working with newest code

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
slyrye
Posts: 4
Joined: Sun Mar 06, 2016 8:07 pm

Re: Input not working with newest code

Post by slyrye »

Had no choice but to use the old 4.146 release seems working fine however the transmission temperature is not giving correct temp information...!
On my Chrysler voyager 41TE project...!

https://youtu.be/Hvz2VdGLA0o

Enjoy.....!
Post Reply