How do I offer corrections to the assembly manual?

This forum is for general questions you have on assembling and troubleshooting your GPIO board. You can purchase a GPIO board at DIYAutoTune now!
Post Reply
Homer Jones
Posts: 4
Joined: Tue Feb 24, 2015 12:47 pm

How do I offer corrections to the assembly manual?

Post by Homer Jones » Thu Feb 26, 2015 10:53 am

I think a phrase in step 3 needs correcting. It looks as if an editing attempt was interrupted (happens to me all the time). I think:
"In all cases, you solder the insert the component on the top side of the PCB..." should read; "In all cases, you insert the component into the top side of the PCB..."

Bernard Fife
Posts: 1696
Joined: Fri Apr 04, 2008 1:28 pm

Re: How do I offer corrections to the assembly manual?

Post by Bernard Fife » Sat Feb 28, 2015 9:24 am

HJ,

Just post suggestions in a thread as you have done. It generally helps if you include a link to the specific web page, but I will find this easily enough and fix this right away. Thanks for spotting it and bringing it up!
"Never wrestle with pigs. You both get dirty and the pig likes it." - George Bernard Shaw

Post Reply