Page 1 of 1

4L80e Build and testing with the Transtim

Posted: Sun Nov 18, 2012 11:47 am
by Adrian
I am building the GPIO board for a 4L80e 2005 transmission.
On step I5 in the instructions, you say to install r59 and r62. Should the r62 be r61 instead? Since there are no other parts installed in the VR4 area.

My next question, is there a cross reference for the AMP seal pin (wires) to the Transtim for testing?

Re: 4L80e Build and testing with the Transtim

Posted: Sun Nov 18, 2012 7:13 pm
by dch
Adrian
yes the resistror goes in R61 and there is no crossfrerance for the sim just fallow the the wiring diagram

Dave