4L80e Build and testing with the Transtim

This forum is for general questions you have on assembling and troubleshooting your GPIO board. You can purchase a GPIO board at DIYAutoTune now!
Post Reply
Adrian
Posts: 2
Joined: Fri Nov 16, 2012 11:58 am

4L80e Build and testing with the Transtim

Post by Adrian » Sun Nov 18, 2012 11:47 am

I am building the GPIO board for a 4L80e 2005 transmission.
On step I5 in the instructions, you say to install r59 and r62. Should the r62 be r61 instead? Since there are no other parts installed in the VR4 area.

My next question, is there a cross reference for the AMP seal pin (wires) to the Transtim for testing?

dch
Posts: 33
Joined: Thu Apr 17, 2008 3:02 am

Re: 4L80e Build and testing with the Transtim

Post by dch » Sun Nov 18, 2012 7:13 pm

Adrian
yes the resistror goes in R61 and there is no crossfrerance for the sim just fallow the the wiring diagram

Dave
49 Willys panel wagon, 383stroker, Hilborn EFI conversion,msII v3, EDIS ,4L80E Image

Post Reply