Zf hp24eh

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
Post Reply
Zenrangie
Posts: 1
Joined: Sun Nov 24, 2013 5:03 pm

Zf hp24eh

Post by Zenrangie »

Hi there..Zenrangie here, london england

New too megashift,but not ms products..
So Rather than bring up old threads......

Looking to control hp24eh on a range rover classic project.anyone willing to share their
Experiences?
I see 2 or 3 have tried but no real info posted
Have msq's for 1uz-fe boosted if anyone wants on ms3x..dual maps etc..(yes wrong forum,but
I suspect if you on here then you are on the other ms forums too

Thanks
Post Reply