CAN pass through

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
Post Reply
roarin_mouse56
Posts: 7
Joined: Wed Aug 23, 2017 9:47 am

CAN pass through

Post by roarin_mouse56 »

Does the CAN pass through work with MegaShift and MS2 Extra?
Rukavina
Posts: 47
Joined: Fri Aug 15, 2014 7:58 pm

Re: CAN pass through

Post by Rukavina »

Yes I run ms2 v3 with gpio board together on canbus
roarin_mouse56
Posts: 7
Joined: Wed Aug 23, 2017 9:47 am

Re: CAN pass through

Post by roarin_mouse56 »

Are you running MS2Xtra?
Rukavina
Posts: 47
Joined: Fri Aug 15, 2014 7:58 pm

Re: CAN pass through

Post by Rukavina »

Msextra 3.4.2
Post Reply