Ford 5R55

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
Post Reply
phillyc
Posts: 1
Joined: Mon Apr 03, 2017 4:17 am

Ford 5R55

Post by phillyc »

G'day guys and girls. This is my first post here.
I'm putting a Ford DOHC Mod motor into an Australian early 1964 Falcon. Will be either a bored and stroked motor.
The 5r55 has really good ratio spreads and think this would be a great gearbox for the application.

5R55S Gear Ratios
First Gear: 3.250
Second Gear: 2.440
Third Gear: 1.550
Fourth Gear: 1.000
Fifth Gear: 0.750

It can also be built to withstand 1025hp according to TCI
http://www.tciauto.com/tc/super-streetf ... -4-6lhtml/

Has anyone on here did the MSGPio MegaShift controller with the 5R55? Is there any technical reason why it can or cant be done?

Thanks
Phil

Image

Image

Image
Post Reply