CAN files missing from V5 template Embedded Code

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
Post Reply
steveh66
Posts: 11
Joined: Tue Oct 23, 2012 7:26 am

CAN files missing from V5 template Embedded Code

Post by steveh66 »

Has anyone uploaded the MShift™ V5 DIY 'Template' Embedded Code lately??

I compile it without making changes and find that the com (CAN) file(s) are missing.... is it just me??
com file error.gif
com file error.gif (180.33 KiB) Viewed 28885 times
Post Reply