Code download

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
Post Reply
Rukavina
Posts: 47
Joined: Fri Aug 15, 2014 7:58 pm

Code download

Post by Rukavina » Wed Dec 07, 2016 10:31 pm

Laptop crashed and had to reload everything. While redoing all my tuning stuff had to download current gpio code and can't "right click and save as" with windows 10 "edge" browser. Went into house and used desktop that runs "windows explorer". That worked fine. Just a fyi. Maybe you can notate page about possible issue with edge

Post Reply