Megasquirt 3 with a Megashift gpio board
Posted: Sun Sep 18, 2016 9:55 am
I have tried to search for this but.....
The following words in your search query were ignored because they are too common words: setup 4l60e.
You must specify at least one word to search for. Each word must consist of at least 3 characters and must not contain more than 14 characters excluding wildcards.
I need to know how to setup a MS3 box to communicate with a Megashift GPIO board. I have tried to follow the manuals and all but i get error that make no sense....Using the s19 file and the ini file i am told to use online i get
Can device Firmware signature mismatch
Current conf serial signature MShift 5.201
Controller req serial signature MS3 format 0524.05
Cotroller reportedfirmware signature MS3 1.4.1 release
The following words in your search query were ignored because they are too common words: setup 4l60e.
You must specify at least one word to search for. Each word must consist of at least 3 characters and must not contain more than 14 characters excluding wildcards.
I need to know how to setup a MS3 box to communicate with a Megashift GPIO board. I have tried to follow the manuals and all but i get error that make no sense....Using the s19 file and the ini file i am told to use online i get
Can device Firmware signature mismatch
Current conf serial signature MShift 5.201
Controller req serial signature MS3 format 0524.05
Cotroller reportedfirmware signature MS3 1.4.1 release