Input for manual/paddle mode

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
razzys wagon
Posts: 14
Joined: Sat Nov 28, 2015 8:48 am

Re: Input for manual/paddle mode

Post by razzys wagon »

checking in for an update, any luck?

thanks,
Mark
Post Reply