Anyone working on an implementation for ZF 8HP?

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
Post Reply
Coyote_ar
Posts: 4
Joined: Sat Jan 09, 2016 5:41 pm

Anyone working on an implementation for ZF 8HP?

Post by Coyote_ar »

Hi guys, anyone working on an implementation for ZF 8HP?

Im still very new to both megashift and AT gearboxes, so im still doing a lot of reading on the matter. But im very interested on using this gearbox in the future.

Regards.
Post Reply