tps problem

A forum for discussing applications and implementations of the MegaShift transmission controller code for the GPIO from B&G. This can control up to 8-speeds and 6 shift solenoids (plus a 16x9 table for controlling a PWM line pressure valve). It has manual and fully automatic modes (16x9 load x speed table), with under and over rev-limit protection, and full data logging of all inputs and outputs (among many other abilities). A TransStim to test your completed board is also available.
Post Reply
killving
Posts: 4
Joined: Sat Jun 24, 2017 7:01 am

tps problem

Post by killving » Thu Aug 17, 2017 9:35 am

I am having issues calibrating the tps i'm just getting this Message.
unable to register tp adc output channel tps adc?

I have included a picture, the tps gag in the Picture doesn't move. But the pressure Control response?
ps The tps is working with the multimeter

Matt Cramer
Posts: 55
Joined: Thu Apr 17, 2008 5:19 am

Re: tps problem

Post by Matt Cramer » Tue Aug 22, 2017 6:12 am

I believe you contacted us by email; I was able to get the same error message, as shown:
tpserror.PNG
Error message
tpserror.PNG (15.21 KiB) Viewed 276 times
However, it's difficult for me to match forum posts to emails, so I do not have a copy of the tune. Can you please post that?

killving
Posts: 4
Joined: Sat Jun 24, 2017 7:01 am

Re: tps problem

Post by killving » Tue Aug 22, 2017 12:52 pm

her is the tune file:-) and yes i contackted you by mail:-)
Attachments
2017-07-16_17.32.51.msq
(62.01 KiB) Downloaded 9 times

killving
Posts: 4
Joined: Sat Jun 24, 2017 7:01 am

Re: tps problem

Post by killving » Fri Aug 25, 2017 6:41 am

hei did you figure it out.
or how did you triger it?

marlypreorm
Posts: 1
Joined: Wed Nov 22, 2017 10:33 am

tps problem

Post by marlypreorm » Fri Nov 24, 2017 10:21 am

I had exactly the same issue setting up my tps on my 91 diablo. I did point this out to John.
The whole truth about a vehicle’s history on a blockchain. www.twitter.com/VINChain_io

Post Reply