MSgpio.com read only forums (Jan.15,2018)

Back in vegas
Not sure my tunes will help you being I am on ms2 and 4l80e but I will put them up tomorrow

Been like the desert here

Driving from Miami to Vegas. Rescue the x wife :evil: anyway I am on ms2 v3 code msextra 3.4.2 and gpio w/ 5201. Other than a new issue with the vss page in tuner studio crashing due to a stack overflow..... if I remember right..... that started on the last upgrade. They are going to fix it in the n...

Sitting in airport and did a quick check and yes general settings, idle up adjustments. You can set timing and air idle. And the other is under timing and fuel adjustments. I am running a 4l80e so my settings won't swap. Also it's better to tune yourself so you know all the details. =disclaimer= I a...

Yes for both. I am on msextra 3.4.2 and gpio 5201 at the moment. I have not had a chance to go 5202 yet. I believe the fixes were due to something I had issue with. There will also be fixes in tuner studio on its next version for the same problem too. I can double check today if idle up is there or ...

Question. Have you thought about firmware update? 5202 is the latest and it does have can comm fixes in it regarding issues with msextra tuner studio and pages crashing due to overflow..... I think. Either way it's a lot newer than what you are running. I think 4146 was the first code I loaded 3.5 y...

I would take 20 min and hook up manual shift buttons. I used a 3 position return to center toggle and a on/off switch for mine but anything will work. If you have any problems like a honkey vss signal you can shift thru gears to get you home.....
And it's fun as he'll too

so not that I am a genius with this.... I am slowly learning this on my own. I looked at your current tune and one you posted a year or so ago. at least you are on the newest firmware. other than minor differences with your setup and mine I didn't notice anything out of the ordinary. I looked at all...

Hey can you also post your tune so I can look at your settings

On phone at the moment so...... if you know for a fact it is shifting I would check your tps/map table settings first. It blends a weighted map vs tps signal over tps I think. But it adjusts your final load for your table. Also ground your 2nd table wire or make table 2 identical to one just in case...