MSgpio.com read only forums (Jan.15,2018)

Thanks for that Lance, loading it up in TS I get an error:

hyst_timer value of -2.147483648E8 is too low.
Must be greater than : 0.0

Lance, At this point the only functionality that the VW/Audi audi transmission requires thats not in the software is the ability to activate the upshift selective clutch when TCC is being engaged. I'm currently doing this using an Arduino, it monitors the TCC solenoid transistor and when it sees it ...

I've just found that I never downloaded vii, I went straight from vi to viii. This means when I tested viii it was combined with the ini file for vi

Would this explain a few things? sorry if this means you've been on a wild goose chase....

Lance, can you confirm something for me? If I set TPS load to 50% does that mean 'load' becomes the average of TPS(%) and CAN load (KPA)? So if TPS is a steady 30%, the TPS/REV table cell is 100 and CAN load is 70KPA then 'load' will be 50 (KPA)? and if TPS is a steady 30%, the TPS/REV table cell is...

Lance wrote:Martin,

Were the above logs with 5.099zvii or 5.099zviii?

Lance.

Hi Lance, those two logs are with the latest 5.099zviii

OK, tried the new code.. not good, see log attached

avload is either 100kpa or 0kpa... I tried to drive it, it nearly killed me.

Thanks Lance, It looks like our thinking is starting to converge.. or maybe I'm understanding better ;) You remember a few weeks ago I asked you to alter the code to allow the hysteresis to use avload instead of instant? that was because I felt that spikes in the load when shifting were turning off ...

If you're interested here is an edited log from this morning...

Not yet! I decided to drive the car to work this morning so I quickly uploaded the new code and logged the run to work. I may be able to try the TPS on the way home, is there anything else I need to do other than sliding it across? any other settings?

I got to test the new code this morning, didn't fix the problem I'm afraid..

I'll post the log later today.