MSgpio.com read only forums (Jan.15,2018)

That seems the most reasonable place to get the signal to me.

Can you post what version number of TunerStudio and what MS2 fimrware version you're using?

Ashford also has a build thread here: viewtopic.php?f=4&t=635

Another possibility would be to put a potentiometer on the supply voltage side.

From a code standpoint, could they be PWM'ed in response to a switch input?

This should be doable, although I'm not sure it has been done before. There is a writeup on setting up MegaShift on transmissions that don't have a specific build guide here:

http://www.msgpio.com/manuals/mshift/newtrans.html

The RFP30N06LE was discontinued, so we substituted the other one as it was already being used for boost control.

Here's what is included. It can populate both VR conditioners, all the high current PWM outputs, and a bit more. Transistors: 10 ZTX450-ND 7 TIP120 1 IRLZ44ZPBF-ND (substitute for RFP30N06LE) 4 2N3904FS-ND Capacitors 8 399-4329-ND 6 399-2017-ND 1 399-4389-ND 4 399-4239-ND 1 399-4301-ND Resistors: 31...

Depends on exactly what inputs and outputs are needed.

Here's a proposed pinout that I sent to Chris already; I'm posting this for the benefit of anyone else who may be reading this thread. GPIO pin 1 12V power 2 VSS input 3 Brake sensor 4 5 2WD / 4WD switch 6 Overdrive switch 7 8 9 10 11 12 13 CANH to ECU 14 15 16 CANL to ECU 17 Sensor Ground 18 Ground...

Our basic kit has the SMD parts, case, heat sink, and power supply but does not have the parts to populate the I/O circuitry.