MSgpio.com read only forums (Jan.15,2018)

For customer I have msshift a 4hp24 in a Freelander (only the looks, it has a tube frame) offroad rally car, the engine is controlled by a MS3pro. It has already some miles on it but it is now down because of some other 'problems'. They have also a older Rangerover rally car also ms3(x) but has a co...

Lance,

You have uploaded the old ini with the typo still in it, but I corrected the typo myself and it is working fine now.

Jacco

Lance,

I was away for a week so i'm a bit late with testing, v4.103 PRN led pattern works fine, the separate pattern for P is very nice, but for the N led pattern the 3rd led alternating you can select off,on,2,3 !!!

Jacco

Lance, The prn is working fine now, but i have found another bug in the ledpattern for reverse if i set led 4 on and in alternating pattern led 4 off, led 4 stays on so if i want a flashing 1 blank i get a alternating 1- 7. If i set the basic pattern blank and alternating 1 it works perfect. All oth...

Lance,

Yes success.

I apologize for taking so long on this - I should have spotted this right away.

No worries, some times the easy solution take the longest, now we can do some in car road testing. I had the wheels turning and shifting with the wheels of the ground before.

Jacco

Lance,

- the outputs are working fine now
- in N still 99 with the right input code D 10
- with N 3rd input code swapped D still 10 N 25
- what change is in R the current gear indicator is 0 in stat of -1

Datalog Jacco

Lance,

I was testing some more and i saw that the sol output 2 is on when i power on the gpio in PRN, output 2 on is the setting for gear 1, in PRN they both should be off. Also if i go from any gear to PRN the outputs stay on or off in PRN depending on the last gear setting.

Jacco

Lance,

I tested the code still no success. With the right inputcode i have code 10 for P and 99 for N , if i change the input code of 3rd and N around (in N all low) it works perfect but i get 10 for D and 25 for N Jacco

Lance thanks for the fast replies, i have bench tested your fix but unfortunately no success. When testing i found out if you set all 3 inputs low for N it works but that is 3rd for my shift-lever (i switched those in the TS shift-lever setup when testing) it works in v4.1 v4.101 and v4.101b Attache...

I'm working on a Rangerover with a zf 4HP24 that not a problem so far the shifts are working it is not that different, canbus with the ms3 works. The problem I have is that the gearlever input for P and N is different while for a gm its the same, i can set it up different in TS but its giving a erro...