MSgpio.com read only forums (Jan.15,2018)

I believe you contacted us by email; I was able to get the same error message, as shown:
However, it's difficult for me to match forum posts to emails, so I do not have a copy of the tune. Can you please post that?

Are you using a USB adapter, or a direct serial connection? If it's a USB adapter, what sort?

Can you post the complete MSQ?

Can you use the Create Project Backup tool to save the entire project and post it up here?

Are you trying to connect to the MegaShift directly, or connect to it as an added CAN device?

I would just start with full line pressure across the board, and back it off until the shifts each your desired level of softness.

A lot of the Mopar RWD automatics are a bit odd - instead of using discrete shift solenoids, they use a PWM circuit for the governor pressure, with closed loop feedback. It would require a code change to give an option of shifting by pressure control instead of solenoid patterns.

Yes, the MS3 firmware on the MS3-Pro can be used with the MegaShift code as well as the MicroSquirt code.

This is more likely an engine tuning issue than a problem with the GPIO.

Do you have a data log of this behavior?

We've been selling the PCB for a while, but now you can buy a DIY kit with everything in the BOM on it, ready to assemble. Check it out here: http://www.diyautotune.com/catalog/transstim-transmission-control-test-board-unassembled-kit-p-590.html http://www.diyautotune.com/catalog/images/trnsstim-c_m...