MSgpio.com read only forums (Jan.15,2018)

I installed the jumper between AD2 and GP13 and the gauge is now reading correctly. I completely missed the whole jumper chart. It would be nice if in the instructions the chart was labeled as a "Jumper chart" so that it is easier to recognize. When building the controller i saw the chart ...

All of my temps are Fahrenhiet, not Celsius. My problems with the temperature reading started with the default settings. I tried to adjust them to the specs in my repair manual to see if it would fix the problem but it did not. When I checked the resistance of the sensor it was around 40-50 degrees ...

I have a 1996 chevy LT1/4L60E that is connected to a MSii v.3 and MS GPIO controller. I am running firmware 2.905 on the Megasquirt and 2.1111 on the GPIO. Using TunerStudio to connect to the MS, I get a Tranny temperature that reads 245-250 degrees. The engine has never been started. The shop tempe...

I am hooking up a MSII and a GPIO to my 1996 LT1 with a 4L60E tranny. Everything I have read says that the default settings for the GPIO is for the 4L60E. Can I just run the default settings and not have to worry about them?