Search found 6 matches

by ruirito
Tue Aug 07, 2012 1:50 pm
Forum: GPIO Assembly
Topic: Thermocouple wiring to GPIO board?
Replies: 10
Views: 33519

Re: Thermocouple wiring to GPIO board?

Ok Matt. I had already saw it at digikey site but didn't know that it was called silver solder.
Long time in a dead end for no big reason.
Thanks
by ruirito
Mon Aug 06, 2012 6:14 am
Forum: GPIO Assembly
Topic: Thermocouple wiring to GPIO board?
Replies: 10
Views: 33519

Re: Thermocouple wiring to GPIO board?

Thanks Matt and ok... seems logic. But why is so difficult to find? Is it 100% pure silver?
Maybe if I use this http://www.labfacility.com/pcb-mounting ... -p168-pg71 I don't need to solder?! I will check for dimensions compatibility.
by ruirito
Sun Aug 05, 2012 11:47 am
Forum: GPIO Assembly
Topic: Thermocouple wiring to GPIO board?
Replies: 10
Views: 33519

Re: Thermocouple wiring to GPIO board?

Hello,
I'm still wondering about the silver solder. Is it really silver solder or is it a technique named silver soldering?

Best Regards,

Rui Rito
by ruirito
Mon Jul 16, 2012 3:44 pm
Forum: GPIO Assembly
Topic: Thermocouple wiring to GPIO board?
Replies: 10
Views: 33519

Re: Thermocouple wiring to GPIO board?

Hello Troy.

I also have a GPIO running and my next step is to connect the 4 EGT. I really like the bulkhead connector idea and I think I will use that one. And what about the soldering? Where you able to find the silver solder?

Thanks,

Rui Rito
by ruirito
Mon Jul 16, 2012 2:35 pm
Forum: DIY GPIO Code
Topic: Base GPIO code to work from?
Replies: 50
Views: 267233

Re: Base GPIO code to work from?

Thanks Lance... Code already running and reading engine oil pressure. I also edited the .ini file and ok. Next step is to read the EGT. But the problem is that I don't know were to find silver solder and what kind of connector should I use to plug and unplug the EGT sensors. Can you give some advise...
by ruirito
Thu Jul 12, 2012 3:20 pm
Forum: DIY GPIO Code
Topic: Base GPIO code to work from?
Replies: 50
Views: 267233

Re: Base GPIO code to work from?

Hello, I'm just starting to assemble and tune my GPIO. My GPIO is to read and control some things in the car and not to control any gearbox. For a start I'm trying to read the engine's oil pressure. I already built the circuit at GPI3. I edited the template that is http://www.msgpio.com/manuals/ioco...