Hello
I´m running MS III and GPIO megashift linked via can and have no trouble getting tach and map signal from MS to GPIO.
I´m trying to get VSS signal from the GPIO to MS. VSS is working good in GPIO but I can´t get the signal over to MS.
The reason for this I want to read speedo on a tablet ...
Search found 3 matches
- Sun Nov 06, 2016 1:43 pm
- Forum: MegaShift Transmission Application
- Topic: VSS from GPIO to MSIII over can
- Replies: 1
- Views: 11606
- Tue Jan 05, 2016 9:16 am
- Forum: MegaShift Transmission Application
- Topic: Input not working with newest code
- Replies: 10
- Views: 221504
Re: Input not working with newest code
Lance
I just tested the new code and everything seems to be working so far.
Thank you for quick response, now I can go on with my project.
Stefan
I just tested the new code and everything seems to be working so far.
Thank you for quick response, now I can go on with my project.
Stefan
- Mon Jan 04, 2016 12:35 am
- Forum: MegaShift Transmission Application
- Topic: Input not working with newest code
- Replies: 10
- Views: 221504
Input not working with newest code
When using the latest code (5.104) for megashift input2 always stays low no matter what, I use the three inputs 1,2,3 for digital shift lever.
The circuit is working properly it gives 5V to processor and 0V when grounded.
When I switch to older code (4.146) everything works as it should.
Anybody ...
The circuit is working properly it gives 5V to processor and 0V when grounded.
When I switch to older code (4.146) everything works as it should.
Anybody ...