Hello Lance,
Although the instructions recommend to first confirm communication with the included .s19 file, I went on and compiled a new .s19 file in CW without any modifications to the code and flashed it in with MS download 2.0 and guess what... Communication with TS is working just fine now!
I ...
Search found 2 matches
- Sun May 12, 2013 10:39 am
- Forum: DIY GPIO Code
- Topic: Base GPIO code to work from?
- Replies: 50
- Views: 979927
- Sun May 12, 2013 3:05 am
- Forum: DIY GPIO Code
- Topic: Base GPIO code to work from?
- Replies: 50
- Views: 979927
Re: Base GPIO code to work from?
I have tried to get the serial communication with TS running for several times now with this new firmware.
The .s19 file seems to flash to the controller as it should, but ones I try to detect the board from TS I get this error message:
"A controller was found on COM3. However there appears to be no ...
The .s19 file seems to flash to the controller as it should, but ones I try to detect the board from TS I get this error message:
"A controller was found on COM3. However there appears to be no ...