Search found 5 matches

by GordonP
Mon Mar 18, 2013 4:24 am
Forum: DIY GPIO Code
Topic: What does the GPIO use for a bootloader?
Replies: 7
Views: 25914

Re: What does the GPIO use for a bootloader?

Thanks Lance.
by GordonP
Sun Mar 17, 2013 1:10 pm
Forum: DIY GPIO Code
Topic: What does the GPIO use for a bootloader?
Replies: 7
Views: 25914

Re: What does the GPIO use for a bootloader?

I would like to make some minor changes to the bootloader to ensure that certain port pins are set to a known "safe" state during code download. I would like to be able to reprogram without worrying about having to remember to unplug a couple of high current solenoids. Is the actual bootlo...
by GordonP
Sat Feb 09, 2013 6:02 pm
Forum: MegaShift Transmission Application
Topic: Motorcycle Gearbox Control
Replies: 4
Views: 6675

Re: Motorcycle Gearbox Control

Thanks Lance. I haven't got very far with this project yet, but was wondering if the template code project that you mentioned would run ok on an MS2 ECU. The reason I ask is that I bought one of these a few years ago, but never got round to using it! The MS2 that I have has the V3 pcb and MS2 daught...
by GordonP
Thu Dec 06, 2012 4:55 am
Forum: MegaShift Transmission Application
Topic: Motorcycle Gearbox Control
Replies: 4
Views: 6675

Re: Motorcycle Gearbox Control

I'm guessing, by the eerie silence, that nobody has tried controlling a motorcycle/sequential gearbox with the MSGPIO?
by GordonP
Sun Dec 02, 2012 2:03 pm
Forum: MegaShift Transmission Application
Topic: Motorcycle Gearbox Control
Replies: 4
Views: 6675

Motorcycle Gearbox Control

I am investigating suitable hardware for use with a sequential motor cycle gearbox, and wondered if the Megashift would do the job. Basically, there would be three actuators, one for indexing the gear selector barrel, one to operate the clutch, and one for blipping the throttle on downshifts. I'm no...