Search found 6 matches

by magnamx-5m
Sat Aug 24, 2013 7:40 pm
Forum: GPIO Assembly
Topic: Why wont the pms work
Replies: 4
Views: 18082

Re: Why wont the pms work

I finally traced this to a burned out pcs (forcemotor) I get normal activation now thanks for all the help.
by magnamx-5m
Tue Dec 18, 2012 3:39 pm
Forum: GPIO Assembly
Topic: Why wont the pms work
Replies: 4
Views: 18082

Re: Why wont the pms work

4l60e there is nothing to log but here is a recent msq
by magnamx-5m
Tue Dec 18, 2012 5:56 am
Forum: GPIO Assembly
Topic: Why wont the pms work
Replies: 4
Views: 18082

Why wont the pms work

I am at my wits end with this gpio. I get 5 volts out to the appropriate ports and down to the pressure manifold switch but, and if i ground the wire inside the connector to the pressure manifold switch it changes state, on my outputs. Reading the emperature works correctly etc, i just cant seem to ...
by magnamx-5m
Wed Oct 03, 2012 4:07 am
Forum: GPIO Assembly
Topic: GPIO BOARD CUT to short. TRACES NEEDED!!
Replies: 2
Views: 16174

Re: GPIO BOARD CUT to short. TRACES NEEDED!!

http://www.msgpio.com/manuals/ this is all i can think of man GL to you
by magnamx-5m
Sun Aug 12, 2012 6:11 pm
Forum: GPIO Assembly
Topic: Gpio works to flash initial firmware and then nothing
Replies: 3
Views: 16537

Re: Gpio works to flash initial firmware and then nothing

I had a few jumpers work loose inside the ms on the 24*2 baord i reinstalled them and then i was able to communicate with the serial com. After checking all my settings it looks like i tried to laod a corrupted file so now i'm i the process of making sure that everything is set accordingly thanks ve...
by magnamx-5m
Tue Aug 07, 2012 8:29 am
Forum: GPIO Assembly
Topic: Gpio works to flash initial firmware and then nothing
Replies: 3
Views: 16537

Gpio works to flash initial firmware and then nothing

How do i check to make sure i haven't shorted my gpio processor etc? I had previusly assembled and bench tested the unit and everything seemed fine the bootlaoder worked and i could interact with it directly via tuner studio. But since i have installed the unit in my vehicle and wired it all up i ha...