MSgpio.com read only forums (Jan.15,2018)

Lots of smileys today...

I when I changed GPI1 input usage to "log ony" it goes to table 1.

After few hours adjusting and learning this code feels to be quite stable! My shifting problem seems to be that I have shift table 2 in use. I was wondering why table 1 adjusting didn´t work :D And I go back to ms-II outpc size to 512 and nothing wrong with that also. I haven´t noticed any strange ...

I can´t stay in bed now... :D

I notice that when we accept wider canbus offsets there should not be same offsets in use that in ms3. That will cause troubles. I dropped ms-II outpc size to 338 to avoid that. But at least small step forword :)

Edit: I get gear detection work in ms3 with JaccoF ...

Congratulations Lance and co! It´s working now!!! I send to ms3 0-5V singal input as vss from stimulator spare 0-5V output and get it to GPIO as speed!!

There is few issues with gear shifting and "Hyst clean" indicator is broken, but now we can get vss from ms3 to GPIO :mrgreen: When I get better I ...

Thanks to You Lance!

I get fever yesterday but have to try this! I load code to gpio and TS, but get still that "canVSSofset value too high" note. I try to change that "MS-II outpc size" higher but that wound´t help. Might this 255 limit be in TS?

BR
Vesku

I try to send vss1 from MS3 to GPIO but have no luck yet. I try to modify .ini file as told...

Code: Select all
[OutputChannels]
deadValue = { 0 } ; Convenient unchanging value.

ochBlockSize = 112
ochGetCommand = "a\x00\x06" ; Lower case so we don't get confused.

seconds = scalar, U16, 0, "s ...

Here have been quiet in this topic... I´m planing to use 722.6 box with ford v8 engine and have been tried to learn how this gearbox works.

Is it possible to make with reasonable amount of work and time solenoid outputs to give just one pulse which time can be adjusted? In Solenoid PWM Setup You ...

This is noobie question, but I didn´t find much information about this. I have turbocharged ford 302 engine and manual T5 after that and like to go 4R70W automatic. Just figuring out choices to control it. I have MS3 controlling engine with full sequential fuel and spark so megashift might be ...