MSgpio.com read only forums (Jan.15,2018)

Thad,

If you don't mind, how much did you pay for the case? If you prefer, you can PM me.

Jean

Thad, If you connect the JimStim to your MS2 then you can use the 5V from it (which actually comes from the MS board) and connect it on the stim (you'll need to connect the ground on both stims together and to the GPIO ground). You also have 6 LEDs you can use as additional indicators for the GPIO o...

There are 6 LEDs on the JimStim which are connected to 5V through a 330R resistor in addition to the 2 injector, 1 fidle, 1 fuel pump LEDs. However, there is no 5V on the JimStim since it comes from the MS board (same as regular stim). So these LEDs can be used for any grounding output.

Jean

The only difference between the 2 part numbers you mention is that one has a 0.1" lead spacing and the other has 0.2" lead spacing. The rest is identical.

The difference you measure may be in the measurement method since they are rated at 10% tolerance.

Jean

The flanged end is like the standard MS case: it has the small section at 90 degrees from the case end to allow the use of mounting screws. The standard end is just a plate to cover the end. And it seems that the EAS400 (or EAF400) is only available from LMB Heeger. There are substitutes (from http:...